Omron STC-SC33POE GigE 1/3" CCD ICX424, 0.3MP Color GigE Camera (Discontinued)
*Product is discontinued, Replacement Option: STC-MCS43POE
The GigE PoE HS Series STC-SC33POE 0.3MP PoE Color Network Camera uses a 1/3" CCD sensor to capture color images at a resolution of 0.3MP (VGA) (CCD Sensor : ICX424AQ)
The STC-SC33POE is part of Sentech's Brand New Power over Ethernet GigE camera series. It features a 1/3" color VGA sensor, 90fps and communication over a 6 pin Hirose or Ethernet connector. The STCSC33POE boasts a compact 35(w) x 35(H) x 55.9 (D) mm size, a user-programmable Area of Interest (AOI) and a Gamma Table that can be imported. This camera meets all industry standards for GigE Vision® and GenICam™, and is compatible with all standard industry drivers. The GigE PoE series is available now at an extremely low cost.
Features:
- User Programmable AOI
- Power Over Ethernet
- 0.3 Megapixel Resolution with 90 fps
| Imager | 1/3” interline VGA color progressive CCD: ICX424AQ |
| Total Picture Element | 692 (H) x 504 (V) |
| Active Picture Element | VGA: 648 (H) x 494 (V) |
| Chip Size | 5.79 (H) x 4.89 (V) mm |
| Cell Size | 7.4 (H) x 7.4 (V) um |
| Scanning System | Progressive |
| Vertical Frequency (Frame Rate) | 89.91172 Hz at full resolution; 0.72028 to 360.33325 Hz changeable via the communication; Maximum frame rate is dependent on the AOI setting; Maximum frame rate of the camera (360.33325 Hz) is 104 vertical resolution AOI setting. |
| Horizontal Frequency | 47.2028 Hz |
| Pixel Frequency | 36.818175 MHz |
| Noise Level | |
@ 8bit output | <= 3 Digit (Gain 0 dB) |
@ 10bit output | <= 12 Digit (Gain 0 dB) |
@ 12bit output | <= 48 Digit (gain 0 dB) |
| Minimum Scene Illumination | 25.75 Lux at F1.2, 89.91172 Hz |
| Sync System | Internal |
| Video Output | Digital 8 ,10 or 12 bit Raw Data or RGB 8 bit |
| Interface | PoE: IEEE802.3af CLASS3 (1000BASE-T) |
| Protocol | GigE Vision 1.2 and GeniCam 2.0 compliant |
| Exposure Time | Preset continuous mode: 10 seconds to 16,777,216 seconds; Preset trigger mode: 10 seconds to 16,777,216 seconds; Pulse width mode: 10 seconds to Unlimited. |
| ALC | Electronic iris and AGC (ON/OFF) |
| Gain | 0 to 20.4 dB |
| Gamma | Gamma 1.0 (Factory default) or downloadable gamma table |
| AOI Function | Programmable AOI setting via the communication |
| Smear Reduction | Selectable ON/OFF via the communication |
| Color Interpolation | Available on RGB output |
| White Balance Function | Auto, Manual, and push to set white balance is available on both Raw Data output and RGB output. |
| Trigger Mode | Edge preset trigger, pulse width trigger (unlimited exposure time) |
| Communication | UART communication through Ethernet Port |
| I/Os | One opt isolated input and two open collector outputs |
| Power | |
Input Voltage | +10.8 to +26.4Vdc through power/IO connector or Power Over Ethernet; (Auto detection with power/IO connector prioritized) |
Consumption | 12V: 2.9W / 2.7W, PoE: 3.4W / 3.1W |
| Dimensions | 35 (W) x 35 (H) x 57.3 (D) mm excluding connectors |
| Optical Filter | IR cut filter on |
| Optical Center Accuracy | Positional accuracy in H and V directions: +/- 0.3 mm; Rotational accuracy of H and V: +/- 1.5 deg. |
| Material | Aluminum (AC) |
| Lens Mount | C Mount |
| Connectors | RJ45 connector; Power/IO connector: HR10A-10R-6PB (Hirose) or equivalent |
| Camera Mount Screws | Two ¼” Tripod screw holes (one each on top and bottom plate); Twelve M4 screw holes (four each on top, bottom, and two each on both side plates) |
| Weight | Approx. 130 |
| Operating Temperature | |
Minimum | Environmental Temperature: -5 deg. C |
Maximum | Environmental Temperature: 35 deg. C or camera housing temperature (Top Plate) : 65 deg. C |
| Storage Temperature | Environmental Temperature: -30 to 65 deg. C |
| Vibration | 20Hz to 200Hz to 20Hz (5min/cycle), acceleration 10G, 3 directions 30 min. each |
| Shock | Acceleration 38G, half amplitude 6ms, 3 directions, 3 times each |
| Standard Compliancy | EMS: EN61000-6-2, EMI: EN55011 |
| RoHS | RoHS compliant |
